| |
There
are no simple systems for determining these problems, however, it can
be done according to the following scheme:
ACT
IN THE FOLLOWING MANNER
|
|
TOTALLY
MURKY POOL (Precipitation) |
| |
|
In the event that the pool goes without adequate treatment
(see ABC's of preventive H20),
trying to clear it up by using preventive methods would
be very slow, costly and hard on the equipment; thus, one
opts for forcing, or precipitating, the filth to the bottom
and draining it out.
|
 |
Because of its high specific weight, this product guarantees
precipitation, but it is important that the product not pass through
the filtering material since this isn't able to retain it and
it will mix back in, making it neccessary towait for the mud to
settle again as well as possibly damaging the filtering medium.
 |
It's important to remove all the gel since, otherwise,
it may harden and stain the tile. to insure that no detail
of this process escapes us, it is possible that this product
may form a white creamy layer, wich we must eliminate by
dragging the hose across the surface towards the skimmer,
with the multiport valve in the waste position or by dissolving
this layer and waiting for it to settle to the bottom again.
|
CLAROL
This product is the right choice when our pool is totally murky;
it helps us to quickly clear up the water in our pool no matter
what shape it's in or how filthy it may be by forcing out all
solids.
| INSTRUCTIONS
FOR USE |
|
This product is very easy to use, but it is important
to prepare the pool beforehand in order to guarantee
the results.
|
|
Apply
a chlorine shock with ALKLOR at least 6 hours beforehand.
|
|
|
|
Check that the pH level is not under 7.6 and that
the chlorine level has risen greatly. The righ way
to measure this is with a test kit.
|
|
|
|
In the event that the pH level is under 7.6 apply
SUPER PLUS at 15 min. Intervals until our goal is
achieved. If the chlorine is not very high, repeat
the previous chlorine shock.
|
|
|
| |
|
After:
By
doing this, we insure the homegeneity of the mixture.
|
|
Afterwards, we leave it for 12 hours (depending on the
severity of the problem).
|
|
|
|
Finally sweep the gel that has settled to the bottom to
the drain. The pool must remain unused until the gel wich
has settled to the bottom has been removed.
|
|
|
|
POOL
WITH ALGAE, MOLD OR BACTERIA |
| |
ALGATROL
Algae
is a plant that normally comes in our pool's replacement water.
To be able to reproduce, like all plants, it needs to form roots,
which it weaves into the softest area of the pool, which is beteen
the tiles where it becomes visible. When this plant is not yet
attaced, it is very vulnerable and easy to eliminate and most
of the time, with the simple applications of a chlorine shock,
it dies.
|
|
When
this plant manages to attach itself to some wall or floor,
its characteristic color is alight green, but over time,
if it is not removed, scum, mold and bacteria stick to
it, darkening it until it becomes black, making it, in
such case, very hard to remove.
|
INSTRUCTIONS
FOR USE
| FIRST
STEP |
|
Scrub the affected area, by which we try to remove
the scum and grime that protect it, thereby facilitating
penetration of the product.
|
|
|
| SECOND
STEP |
|
Apply the product and in the event that the problem
is very severe, apply 2 or 3 times the recommended
amount.
|
|
1
lt./60m3
|
|
 |
| THIRD
STEP |
|
After a few hours, scrub the area again thereby removing
the now dead algae. by not removing it, it might serve
to host new algae.
|
|
|
|
| C |
FORMATION
OF SCUM |
| |
SCUM
REMOVER DES HS-450
|
This produc is formulated to remove scum and clean the
ring of grime that forms at the level of the pool water
(cenefa) or in areas that haven't been cleaned over a long
period of time
|
|
|
It can also used in bathrooms, kitchens or other places
where scum builds up, but due to its strong concentration,
in these cases, it must be diluted in from 5 to 20 parts
water.
|
 |
INSTRUCTIONS
FOR USE
|
The way to apply the product is by simply wetting a scrubing
pad with it or by applying it with a sprayer and scrubbing
the area several times (scrubbing pad must be plastic) until
obtaining the desired result. Use latex gloves.
IT'S
IMPORTANT TO CLARIFY THAT WHEN A PROBLEM IS SEVERE, IT WILL
BE DIFFICULT TO ELIMINATE UPON THE FIRST APPLICATION.
|
 |
|
|
